Before placing the strips themselves, we pre-glue the LED strip, cut it in accordance with the dimensions previously prepared slats. In my case, I changed the standard tape of mediocre quality to a proven one I can't say whether in your case there will initially be good tape from 3M on the tape or bad, in any In this case, it will be possible to re-glue it in the future if the tape peels off from the set place.
I cut the aluminum bar into segments in accordance with the size of the TV. For the bar intended for the lower part gave the necessary profile to ensure a fit on the unevenness of the body.
To place the aluminum slats on the TV case, I purchased a textile tape fastener - Velcro. Cut off a few small segments and glued to aluminum slats. At the moment, I am satisfied with such a solution, it is possible In the future, if the slats sag, I will glue them directly to a good double-sided tape.
Layout on the TV case.
Before placing the strips themselves, we pre-glue the LED strip, cut it in accordance with the dimensions previously prepared slats. In my case, I changed the standard tape of mediocre quality to a proven one I can't say whether in your case there will initially be good tape on the tape or bad, in any in this case, it will be possible to re-glue it in the future if the tape peels off from the set place.
Aluminum strips with LED strip are installed. I recommend that you check the performance of the tape before it placed on the TV case, all connections of the contacts of the LED strip to the wire must be securely soldered. In stores there are special connecting corners for the tape, but I do not recommend using them because The connection in them is rather mediocre.
